is revolutionary method for cleaning the “un-cleanable,” including piping, tubes, and process equipment in plastics, chemical, refining, offshore and other facilities.

How it works:

The technology of Hydrokinetic cleaning process is based on the induction of “sonic resonance” into the cleaning water stream. This sonic resonance travels through the water stream and safely transfers to both the tube and the fouling material. Because of the different compositions of the tube and the fouling material, they resonate at different frequencies, breaking the bond between them and allowing the fouling material to be expelled quite easily. Hydrokinetics™ is the faster, simpler, safer solution for internal pipes / tubes cleaning services.

Hydrokinetic™ Console


Faster Hydrokinetics™

typically requires only half the time of traditional cleaning methods, saving man-hours, reducing downtime, and increasing the company’s production capabilities.

Safer Hydrokinetics™

is the safest of all the cleaning methods available. Technicians and employees are never exposed to any dangerous, high-pressure water that is commonly used in other cleaning procedures. Safety is built into the HydrokineticsTM design. Instead of chipping away at process line blockage, the fouling material is cleared out of the opposite end of the pipes, away from our technicians and plant personnel.


Is built unto the Hydrokinetics™ design. Instead of chipping away at process line blockage, the fouling material is cleared out at the outlet of the pipes tubes away from our technicians and plant personel.


The process can clean applications where other methods fail. Fully plugged lines, tight spaces, critical path applications or difficult materials. Hydrokinetics™ can clean the lines.

Greener Hydrokinetics™

uses much less water than traditional methods. No chemicals are required. Cleaning jobs typically require less time, reducing the time necessary for the use of motorized equipment.


Most cleaning is performed in place.is one of the concerned in most areas. Moreover, removal of equipment, build expensive scaffolding, and make cuts in piping or chemical disposal. The end result is a much less expensive total job cost.

Creation of scaffolding

Is not required in Hydrokinetic™ method. Therefore more cost effective compared to the conventional clearing method.


PTSB offers a multitude of services that can be tailored to meet the customer’s needs. The following categories listed below will assist you with selecting the type of service that will meet clients requirements.


Entry Level Inspection and very basic inspection. Inspection to include borescope scope to get a view for tight or inaccessible area. We can prepare a scope, then advise if further detailed analysis is required.

  • Urgent one off Responsive Inspection-On an agreed basis
  • ½ day Inspection-Inspection to include 4hrs on site.

This optical device consisting of a rigid or flexible tube with an eyepiece on one end, an objective lens on the other linked together by a relay optical system in between. The optical system in some instances is surrounded by optical fibers used for illumination of the remote object. An internal image of the illuminated object is formed by the objective lens and magnified by the eyepiece which presents it to the viewer's eye.

It can be used in applications such as:

  • Tube Inspection heat exchangers or other
  • Pipe weld inspection from the inside
  • Corrosion detection in tight spaces

Borescope Tools